> For the complete documentation index, see [llms.txt](https://docs-7.phoenixlidar.com/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://docs-7.phoenixlidar.com/rover/hardware/camera/a6k-lite-camera/operating-with-spatial-explorer.md).

# Operating with Spatial Explorer

If the LiDAR system was purchased with the A6K-Lite camera accessory, it will come pre-configured with a factory profile for the camera and it will show under the Sensors section on the right of the screen. From there, the camera can be activated via the **“ACT” button** and stopped via the “OFF” button.

If the A6K-Lite was purchased by itself as an upgrade, then a new profile will have to be created. In this case, please check the following sections [Initial Camera Setup](/rover/hardware/camera/a6k-lite-camera/operating-with-spatial-explorer/initial-camera-setup.md) and [Dual A6K-Lite Setup](/rover/hardware/camera/a6k-lite-camera/operating-with-spatial-explorer/dual-a6k-lite-setup.md).

In the activated state, the camera S**tatus and Activity LEDs** will indicate the following:

* Status LED: Flashes RED when rover sends a trigger signal to the camera.
* Activity LED: Flashes GREEN when the camera recorded an image.<br>